This listing is for one Regulator Seat Seal for Bob Long regulators. I have also tested these with a Palmer's Stabilizer Male regulator.
If you are rebuilding any Gen 1-4 Bob Long Torpedo high pressure regulator or Intimidator low pressure regulator, chances are it will need a new seat seal. These went through various prototyping stages, and are now offered as a finalized product that is a reproduction of the original, in the same durometer and material.
This seal will work for the stock high pressure regulator and low pressure regulator in a Gen 1-4 Intimidator or Defiant 2. These are often referred to as "006 Teflon" in the manuals. The sealing surface must be clean and free of debris for the seat seal to work properly; leaving old, dried-up grease will be a problem. There is no need for any lubricant for these to work properly, but a light coat of oil is sufficient if you just can't let it go in dry.
Each HPR and LPR will require one of these seals. Typically, two are required for a complete Intimidator rebuild. Regardless of any recommendations on this page, I am not liable for damage to your marker. Various blow-up diagrams have been included, and if needed, here are several manuals for Bob Long markers:
